Welcome to the Onshape forum! Ask questions and join in the discussions about everything Onshape.

First time visiting? Here are some places to start:
  1. Looking for a certain topic? Check out the categories filter or use Search (upper right).
  2. Need support? Ask a question to our Community Support category.
  3. Please submit support tickets for bugs but you can request improvements in the Product Feedback category.
  4. Be respectful, on topic and if you see a problem, Flag it.

If you would like to contact our Community Manager personally, feel free to send a private message or an email.

Projecting Geometry

roche_harmonroche_harmon Member Posts: 2
Hi.  I'm new to Onshape.  I'm trying to 3D model a rocket.  I have extruded the tube (revolve) and am now trying to draw a fin.  When I begin to draw the fin, I can not get the cursor to snap to the circumference of the rocket.  Can you project geometry to the second sketch plane so this can be done?

Comments

  • mahirmahir Member, Developers Posts: 1,291 ✭✭✭✭✭
    In this case, you need to use the Intersection command on the revolved surface.


  • NeilCookeNeilCooke Moderator, Onshape Employees Posts: 5,310
    The Use command will also get the silhouette edge. 
    Senior Director, Technical Services, EMEAI
  • mahirmahir Member, Developers Posts: 1,291 ✭✭✭✭✭
    Good to know, but if possible I usually avoid using silhouette edges. They're not the most stable of references.
Sign In or Register to comment.