Welcome to the Onshape forum! Ask questions and join in the discussions about everything Onshape.
First time visiting? Here are some places to start:- Looking for a certain topic? Check out the categories filter or use Search (upper right).
- Need support? Ask a question to our Community Support category.
- Please submit support tickets for bugs but you can request improvements in the Product Feedback category.
- Be respectful, on topic and if you see a problem, Flag it.
If you would like to contact our Community Manager personally, feel free to send a private message or an email.
Options
Extrude did not regenerate properly. Selected offset is too large, decrease the value.
mark_bowman
Member Posts: 4 ✭
in General
I am new to Onshape, and I am working on the wheel tutorial. When I perform step 19 of 23 for Extrude 5, I get the message of "Extrude did not regenerate properly. Selected offset is too large, decrease the value.". I have looked at my drawing and have not found any open areas. Help with this problem would be greatly appreciated.
The link to the drawing is:
https://cad.onshape.com/documents/826f27b9578402200a3000d6/w/15f056327b22d033754f1fdc/e/3b27baab84ef6c4b830cb1d3
The link to the drawing is:
https://cad.onshape.com/documents/826f27b9578402200a3000d6/w/15f056327b22d033754f1fdc/e/3b27baab84ef6c4b830cb1d3
0
Comments
The link to the wheel exercise is below.
https://cad.onshape.com/documents/826f27b9578402200a3000d6/w/15f056327b22d033754f1fdc/e/3b27baab84ef6c4b830cb1d3
I opened your document and found there is no face or sketches to extrude. The blue highlighted box.