Welcome to the Onshape forum! Ask questions and join in the discussions about everything Onshape.

First time visiting? Here are some places to start:
  1. Looking for a certain topic? Check out the categories filter or use Search (upper right).
  2. Need support? Ask a question to our Community Support category.
  3. Please submit support tickets for bugs but you can request improvements in the Product Feedback category.
  4. Be respectful, on topic and if you see a problem, Flag it.

If you would like to contact our Community Manager personally, feel free to send a private message or an email.

Sheet Metal Flanges Over Curved

connor_luckettconnor_luckett Member Posts: 2 EDU
Hi all,

New to OnShape, but I really like it so far with one exception. I'm trying to draw an aluminum aircraft rib. I've done this before in SolidWorks, and I know it works there.

As shown in the photo below, I can add a flange to the rear tab of the airfoil (since it's flat), but I can't add a flange to the top and bottom of the airfoil (because they're curved). Am I doing this wrong? Does anyone have a workaround? All of the tuto

Thanks,
Connor



Comments

Sign In or Register to comment.