Welcome to the Onshape forum! Ask questions and join in the discussions about everything Onshape.

First time visiting? Here are some places to start:
  1. Looking for a certain topic? Check out the categories filter or use Search (upper right).
  2. Need support? Ask a question to our Community Support category.
  3. Please submit support tickets for bugs but you can request improvements in the Product Feedback category.
  4. Be respectful, on topic and if you see a problem, Flag it.

If you would like to contact our Community Manager personally, feel free to send a private message or an email.

Mating Telescoping Parts

patrick_sheapatrick_shea Member Posts: 63 EDU
Is there an easy way to mate a couple of pieces of square tube so they telescope.  I have been using 2 planer mates, but looking for an easier way..

Pat
Tagged:

Comments

  • S1monS1mon Member Posts: 2,321 PRO
    A slider mate centered with the mate connectors centered on the ends of the tubes would work well. You can easily set a limit for the sliding. 

    Assuming you're not modeling everything with line-to-line impossible tolerances, to some degree, how you mate this depends on the philosophical approach you want to take. If you want things to be biased based on one corner, you could keep the planar mates, or use a slide mate with MCs at the corners of the two faces. If you want everything to float with tolerance all around, then my first suggestion would make sense.
Sign In or Register to comment.