Welcome to the Onshape forum! Ask questions and join in the discussions about everything Onshape.
First time visiting? Here are some places to start:- Looking for a certain topic? Check out the categories filter or use Search (upper right).
- Need support? Ask a question to our Community Support category.
- Please submit support tickets for bugs but you can request improvements in the Product Feedback category.
- Be respectful, on topic and if you see a problem, Flag it.
If you would like to contact our Community Manager personally, feel free to send a private message or an email.
offset a spline
Hello,
I am working on making a model for a kids puzzle to 3D print, tracing over a cartoon figure jpeg imported into a sketch. To make the individual puzzle pieces that lock together I planned on making a spline for each part in a sketch and then in another sketch (in a new part) offset the shape of the previous part by some small amount (.50 mm) to create the fit of the joint. But I cannot offset the previous sketch's spline, I get the error 'offset failed, one spline generated multiple offset curves'. Is it not possible to offset a sketched spline?
Bob
I am working on making a model for a kids puzzle to 3D print, tracing over a cartoon figure jpeg imported into a sketch. To make the individual puzzle pieces that lock together I planned on making a spline for each part in a sketch and then in another sketch (in a new part) offset the shape of the previous part by some small amount (.50 mm) to create the fit of the joint. But I cannot offset the previous sketch's spline, I get the error 'offset failed, one spline generated multiple offset curves'. Is it not possible to offset a sketched spline?
Bob
0
Comments
https://cad.onshape.com/documents/76e00336c0da13abcb99de5a/w/2b54a58cb5ca3bfddaa9df1b/e/2bdef804559c38ba4c57062b