Welcome to the Onshape forum! Ask questions and join in the discussions about everything Onshape.
First time visiting? Here are some places to start:- Looking for a certain topic? Check out the categories filter or use Search (upper right).
- Need support? Ask a question to our Community Support category.
- Please submit support tickets for bugs but you can request improvements in the Product Feedback category.
- Be respectful, on topic and if you see a problem, Flag it.
If you would like to contact our Community Manager personally, feel free to send a private message or an email.
Search
-
Trying to make a solid of constant width but can't seem to trim the edge bits.
-
Re: patterns in assembly configurations
Yes, this is possible. Before we go further, you need to decide what you want your driving parameter to be. Total width and height, spacing between bars, or bar widths. It can be any 2 combinations of these, but all 3 at the same time will over-constrain unless they are the exact right numbers. I suggest Total width and… -
How to make different thickness square patterns the same size?
I have two squares with the middle cut out in my sketch, one of them is thicker than the other. I used the linear pattern tool to make a pattern of these two sqaures. It is quite obvious that the two square grids do not share the same length and width even though the original two squares are the same length and width. Is… -
Re: Slicer
It would be nice if there was a FS that could take my printers paramaters (0.6mm layer height, 1.2mm layer width) and represent the model similar to how cura does in the preview window. This way I can tweak it a bit to get rid of any small gaps or infills or places where a full layer width doesn't fit properly. -
How Do I ? Make a vertical width the same as the horizontal height
https://cad.onshape.com/documents/5fd587281ae10ca5381fb830/w/e545b0c197956d7f58969f38/e/1005151602729b69a8f62a5f Total noob here. In the above drawing is a sketch in the Part Studio 1. I would like to add a constraint that the height of the top is equal to width of a side. Not sure what I need to do. The idea is that all… -
Re: How to Spec. a Laser Cut Box for Vendor?
-
Re: normal/ flat chamfer
-
Re: How do I constrain dimensions?
-
Re: Improvements to Onshape - March 22nd, 2018
-
Re: New Custom Feature: Wire Mesh
@NeilCooke This is a great feature script thanks so much. I was wondering how difficult it would be to add a height control as well as a width control to the mesh? I have been trying to model meshes with different constraints for a while i.e a mesh with 37mm width and 17mm height eyelet openings made from an expanded sheet…
491 results