Welcome to the Onshape forum! Ask questions and join in the discussions about everything Onshape.
First time visiting? Here are some places to start:- Looking for a certain topic? Check out the categories filter or use Search (upper right).
- Need support? Ask a question to our Community Support category.
- Please submit support tickets for bugs but you can request improvements in the Product Feedback category.
- Be respectful, on topic and if you see a problem, Flag it.
If you would like to contact our Community Manager personally, feel free to send a private message or an email.
Search
-
Re: Fillet Width Measurement Option Fails Randomly
Using a width measurement with an oblique angle like this, you're falling off the edge of the base surface because the nominal width of your 0.437 radius is much less than the 0.375 or 0.5 widths you tried. You either need a smaller number, or extend the end of the surface first and trim back after. Whenever a fillet… -
Fillet Width Measurement Option Fails Randomly
Quick question, I'm having way too many instances where the "width" option on the fillet tool fails to run. In most scenarios I consider the geometry to be straightforward. In the example below I tried adding the fillet to both solid and surface geometry. If I change the measurement option to radius the fillet will work on…
2 results