Welcome to the Onshape forum! Ask questions and join in the discussions about everything Onshape.

First time visiting? Here are some places to start:
  1. Looking for a certain topic? Check out the categories filter or use Search (upper right).
  2. Need support? Ask a question to our Community Support category.
  3. Please submit support tickets for bugs but you can request improvements in the Product Feedback category.
  4. Be respectful, on topic and if you see a problem, Flag it.

If you would like to contact our Community Manager personally, feel free to send a private message or an email.

interference

Discussion List

  • Is there an API endpoint for checking interference between two parts?

    I am using onshape through API request and I have a question regarding Interence check functionality. For UI, we have interence check option in both Assembly studio and Part studio, but I cannot find the enpoint that does the same functionality. Can someone help me to locate the endpoint that checks the interence of two…

  • How to clean interference in sheet metal?

    I run interference detection for the model. It shows overlaps from the end side of the panel and to the wall, In the first place why does it have interferences even I am using Up To Part as limits?. How to clean this? Is this something about accuracy of the software?

  • Interference in a Hinge

    Is there a command in Onshape that will help me find interference in a hinge? It's probably obvious but section view seems to be the only option I can find.