Welcome to the Onshape forum! Ask questions and join in the discussions about everything Onshape.

First time visiting? Here are some places to start:

Looking for a certain topic? Check out the categories filter or use Search (upper right).
Need support? Ask a question to our Community Support category.
Please submit support tickets for bugs but you can request improvements in the Product Feedback category.
Be respectful, on topic and if you see a problem, Flag it.

If you would like to contact our Community Manager personally, feel free to send a private message or an email.

sketch regions

Sketch can't actually obey "coincident" constraint
So, here's what I did: created a sketch with a spline approximated that spline using Edit Curve to simplify it converted the resulting 3d curve back into 2d by "Use"-ing it in another sketch used "Offset" on the resulting sketch curve added various lines which intersect with the offset curve What I'm observing is that…
Anyone else having "unexpected" things happen to solids when adding entities to a previous sketch??
Hello! Quickly, I created a "main sketch" and extruded a couple of solids from that. Then I went back to the main sketch to add some other entities and the first solids now have voids! OK... modify the solid and add the "new" sketch regions. But when doing a Use and Trim something I am not use to is happening. I quit…
Reusing the same sketch.
Apologies if this was asked before. I couldn't find it. I need to use different parts (regions) of the same sketch to base different features on. I use SW most of the time and I'm used to that. Is it available now and I don't know how to use it? Or will it be added later?

Sketch can't actually obey "coincident" constraint
So, here's what I did: created a sketch with a spline approximated that spline using Edit Curve to simplify it converted the resulting 3d curve back into 2d by "Use"-ing it in another sketch used "Offset" on the resulting sketch curve added various lines which intersect with the offset curve What I'm observing is that…
Anyone else having "unexpected" things happen to solids when adding entities to a previous sketch??
Hello! Quickly, I created a "main sketch" and extruded a couple of solids from that. Then I went back to the main sketch to add some other entities and the first solids now have voids! OK... modify the solid and add the "new" sketch regions. But when doing a Use and Trim something I am not use to is happening. I quit…
Reusing the same sketch.
Apologies if this was asked before. I couldn't find it. I need to use different parts (regions) of the same sketch to base different features on. I use SW most of the time and I'm used to that. Is it available now and I don't know how to use it? Or will it be added later?

Discussion List