Welcome to the Onshape forum! Ask questions and join in the discussions about everything Onshape.

First time visiting? Here are some places to start:
  1. Looking for a certain topic? Check out the categories filter or use Search (upper right).
  2. Need support? Ask a question to our Community Support category.
  3. Please submit support tickets for bugs but you can request improvements in the Product Feedback category.
  4. Be respectful, on topic and if you see a problem, Flag it.

If you would like to contact our Community Manager personally, feel free to send a private message or an email.

extruding uneven faces

Discussion List

  • Extrude

    is it possible to extrude a flat rectangle uniformly below a beam that has faces that vary. Think of the side of a flat car. The side beam is a standard height over most of its length. At either end the height changes at an angle down to a lower height. Across the bottom over the entire uneven portion of the beam is a…