Welcome to the Onshape forum! Ask questions and join in the discussions about everything Onshape.

First time visiting? Here are some places to start:
  1. Looking for a certain topic? Check out the categories filter or use Search (upper right).
  2. Need support? Ask a question to our Community Support category.
  3. Please submit support tickets for bugs but you can request improvements in the Product Feedback category.
  4. Be respectful, on topic and if you see a problem, Flag it.

If you would like to contact our Community Manager personally, feel free to send a private message or an email.

holes clearance tapped

Discussion List

  • Hole Feature Naming

    Is it possible to create a hole feature that names the feature the same as the tap information or clearance information? For example if a hole feature creates a tapped hole for a M3x0.5 screw, the feature would be called M3x0.5, and if the hole feature creates a clearance hole for the M3x0.5 screw, the feature would be…

  • Countersink head size for M4.5 is not correct

    I think the numbers provided by the hole wizard are not correct for Countersink ISO Clearance M4.5 Close clearance M4: hole=4.3 head=8.96 Close clearance M4.5: hole=4.8 head=4.8 <--Head size: 7.5? Close clearance M5: hole=5.3 head=11.2 Normal clearance M4: hole=4.5 head=8.96 Normal clearance M4.5: hole=5 head=5 <--Head…

  • Clearance and tapped holes stopped working.

    I had four holes that are clearance and tapped they worked perfectly, when I went to reopen the model a couple of days ago those holes no longer render. They give the error "did not regenerate properly: None of the holes intersected a part". As you can see from the screenshot I have previously projected these holes to a…