measure

Often in the design process there may be specific geometric constraints on the parts that need to be considered along the way. I created this Sensor custom feature to measure certain geometry and compare it to a specified value and warn if it is out of spec. Currently only edge length and fillet radius are supported but I…

I'm trying to measure the boundary edge of an evaluated face. When using evFaceTangentPlane, if the face is not square, the evaluation will project where the face should be. I can place a plane on the invisible edge shown below with evFaceTangentPlane. However, I'm not sure how to get the length of the invisible edge. If I…

Here is a cool feature I found by @Jason_S. It lets you: measure multiple distances, create in studio variables of measurements, & export a custom table from the measurements taken Measure Multiple by Jason_S (New custom feature!)…

What is a good method for measuring points on a surface within featurescript? Is there a "create mesh" that I can apply to the surface first then measure those points? There must be more efficient way than what I am imagining: - Split the surface into a grid - Measure the split points from a plane

I'm sure I used it when I first started using OnShape. I can't find it anymore. The help files say it should be at the right end of the bottom of the screen, but there's nothing there. Is it only on certain screens? I want to measure some hole diameters on an assembly without going back and editing the sketches. Thanks.