Welcome to the Onshape forum! Ask questions and join in the discussions about everything Onshape.

First time visiting? Here are some places to start:
  1. Looking for a certain topic? Check out the categories filter or use Search (upper right).
  2. Need support? Ask a question to our Community Support category.
  3. Please submit support tickets for bugs but you can request improvements in the Product Feedback category.
  4. Be respectful, on topic and if you see a problem, Flag it.

If you would like to contact our Community Manager personally, feel free to send a private message or an email.

Sketch fillet bug?

nocry3nocry3 Member Posts: 28 ✭✭
Hello,
I create the following sketch and tried to add a fillet to the bottom left 'yellow' point with r=0.75. But I couldn't enter the radius and get an error? Does OnShape try to use the default radius of 2?


Tagged:

Best Answer

Answers

  • viruviru Member, Developers Posts: 619 ✭✭✭✭
    edited December 2016
    @ralf, You could not able to enter the radius and get an error after selection of point because previous fillet given value is 2 which is saved in history. Currently your sketch thickness is 1.8 so you cannot give fillet value more than that.Therefore you need to select edge not point to give fillet to the bottom left 'yellow' point with r=0.75 . Please refer below video for more detail.

  • nocry3nocry3 Member Posts: 28 ✭✭
    Thank you for your help. In my opinion, the behavior of Onshape is not consistent here. Create a fillet should only create a fillet and not also meassure it. Draw a line for example does also not draw a line and meassure in one step.
Sign In or Register to comment.