Standard Content Countersink -- offset?

paul_passarelli Member Posts: 6 ✭✭

February 2018 in Community Support

I created a test part with a screw & cap nut. The screw sticks out of the hole. Is there a workaround?

0

Answers

• 

  philip_thomas Member, Moderator, Onshape Employees, Developers Posts: 1,381

  February 2018

  @paul_passarelli - I think you will find that this post addresses some of your questions.
  
  https://forum.onshape.com/discussion/comment/35349#Comment_35349
  
  
  

  Philip Thomas - Onshape

  0