3D Sketch

I suspect I cannot do a single 3D master 'General Assembly sketch, e.g. to set out all the important reference points that all the subassemblies' parts need to align to (or avoid), like external mounting bolts, pipes, ventilation slots or casing? Can I do an XZ sketch then a YZ sketch with the XZ showing on its plane for…

Hello, We have got this 3D bent spring wire in our product. In SW this already was some hassle to set up using 3D Sketch because it would suddenly give an overdefined sketch for no reason when adding tangent relations between multple arcs in a 3D sketch. However, it was fixed by adding small straight pieces (0,01mm, as you…

With SW this is easy with Extrude from 3D sketch with draft. The entire 3D top curve below can simply be extruded with draft to bottom face. Onshape does not yet support 3D sketches or extrude from 3D curves. I know parting line draft may address this when released. (ex discussion here )…