Barrel cam

Hi, I am attempting to design a simple non-continuous barrel cam for an application. It has a straight section then a section that is at 30deg from the main axis of the cylinder, these are joined by a small circular curve tangent to each. I sketched the centerline, and used the Slot sketch feature to make it the correct…

I found another thread on barrel cams but my question is a little different. I need to model an axial cam for two cam followers. Unlike the groove-type barrel cam, it will have a raised rib with a follower on each side - sort of the inverse of a grooved barrel cam. This a a bit more complicated in that the width of the rib…