bom

Is there a way to generate a custom BOM on a top level assembly that only shows parts with a certain property? For context, I am trying to create drawings of top level assemblies that may contain 50-100 parts, some of which are inside of sub assemblies, and on these drawings there would be a BOM showing only those parts…

I'm working on a design where I need to replicate a single tile component across a base plate in an assembly. The requirements are: Pattern one tile part across the entire plate surface (so only one part appears in BOM) Automatically trim/cut tiles that extend beyond the plate edges so they're flush with the plate boundary…

Two Questions Relating to BOMs and Drawings: I have a multi-level BOM I want to display on a drawing that overflows the 8x11 page I'm using as my drawing template. Is there a way to paginate this BOM so I can break it up into 2 drawings? Or a way to filter just certain levels? See below: If I create a drawing of a top…

Imagine: A shed has four walls with timber frames. We need to create a BOM with all timber (90x45mm section) x length(!) The obvious design is creating the walls using centre lines and creating frames in a Part Studio. (Yes, we also created models based on mating individual parts of timber, but this is a huge amount of…

I'm using FeatureScript to create a pattern of a part. However, when assembled, these patterned parts aren't being recognized as identical in the BOM. This isn't necessarily a problem if I could configure the quantity property, but that isn't the case. I am aware I could add a custom part property and enter the quantity…

Does anyone know of any particular way to integrate OnShape's PDM software with ERP/CRM software (in particular, Dolibarr https://www.dolibarr.org/ for my purposes)? If there were a way to directly import or, better yet, have my list of created assemblies and/or parts just integrate with Dolibarr so 1) I don't have to type…

I’m trying to find a way to generate a BOM without going through the assembly process. My problem is that I use measured variables to calculate the gap between the bars of a ramp. However, once the assembly is done, the variables are no longer accessible. Here are my variables: Railing1 -> Measured NbRailing1 ->…

Hello, well, I have a question about Configuration Properties specifically Part number. I have create a simple configuration and added Configuration properties (Color and Part number). But when I insert different instances in to the assembly and open BOM those Part numbers are not showing. Pleas help, what am I doing…