Configuration Panel
Discussion List
-
How to drive Surface (Face) names via Configuration?
I am looking for a way to explicitly name a Surface entity (Face) based on the active Configuration. The Workflow: Sketch -> Extrude -> Fillet (Base geometry). Offset Surface (Zero offset): I extract a specific face from the solid to use as a master surface for downstream Derives. The Goal: I need the Name of this…
-
Is it possible to name certain dimensions for configurations rather than the default?
When using configurations that have multiple instances in one sketch, it would be helpful to have them be distinct names that could be set. I know that when you hover over the values in the table that it will highlight them, but I would also like to be able to quickly see it in the table, especially as a part gets…