drafts

Hi, I'm trying to model Ghal Maraz in Onshape but I've run into some problems. This is Ghal Maraz upper portion. The neck/throat of the hammer curves inwards as it converges into square. I've been trying to get the draft to curve inwards but I can't seem to be able to do it. I've tried loft but that ended in a failure. Any…

I keep losing my questions before submitting them because of a message that pops up and blocks the submit button. But it keeps saying "Draft Saved". Where are the drafts saved? I'd like to get it back.

Hi All, I am playing with surfaces to cut a solid and I am trying to get a draft solid from my cut, is there a way to get draft surfaces instead of having to add the Draft after? Thanks

So, my first stab at FS is going to be a "Part Draft" feature. I just want to query for a neutral plane, and a body - and I want the feature to split the body with the plane, then draft both sides. I figured I'd start with the draft, then incorporate the split. I could get the draft working when I queried for the faces,…

Probably easy, but trying to figure it out - I'd like to apply a draft angle to the disks in the attached screenshot - what do you use as the neutral plane in this case? or how do you create one? Ideally I would use the base of where they hit the main shaft as the start and apply the taper radially. My "hard way" solution…