drawing dimension
Discussion List
-
Arc length dimension for curved pipe doesn't work in drawing
I'm trying to dimension a curved pipe's arc length in a drawing. I used the dimension tool, clicked start, end, and the arc itself, but this doesn't work. Instead it gives some sort of angle dimension instead. The pipe is created from an arc in the part studio, and I can dimension the arc length without problem in the part…
-
Can I set an offset between the dimension line and the part?
I miss the option to have the same distance between the part and the dimension line consistent throughout the drawing. In Inventor there was a simple setting that allowed quick dimensioning. Is there already an Improvement Request? I would be satisfied to vote for it.
-
Assembly Drawing - Cannot create "zero" (0.00) dimension between parts aligned on the same plane.
I have an assembly drawing of a stack of components. Some of the components need to align on the same plane. On a cross-section, I would like to show that the edges of the two parts can be aligned with some tolerance (i.e. 0.00+/-0.50mm). For the life of me, I cannot create such dimension. I have tried line-to-point,…
-
How to dimension complex part in drawing
I have a "complex" part in that it has various bends and angles and as a part is itself canted in the part studio. I've added it to a drawing (e30 engine bracket | Drawing 1 (onshape.com)) but it seems onshape only does projected dimensions, not actual dimensions. How can I confidently label the dimensions on the various…