Welcome to the Onshape forum! Ask questions and join in the discussions about everything Onshape.
First time visiting? Here are some places to start:- Looking for a certain topic? Check out the categories filter or use Search (upper right).
- Need support? Ask a question to our Community Support category.
- Please submit support tickets for bugs but you can request improvements in the Product Feedback category.
- Be respectful, on topic and if you see a problem, Flag it.
If you would like to contact our Community Manager personally, feel free to send a private message or an email.
Alex_Kempen EDU
Reactions
-
Re: Extrude to opCreateBSplineSurface is not robust
So, this seems more like an issue with opExtrude rather than opCreateBSplineSurface specifically. Up to next is actually handled entirely in the back end by the extrude feature (i.e. opExtrude accept… (View Post)1 -
Re: A design contest again...
So, nobody said FeatureScript wasn't allowed... https://cad.onshape.com/documents/eebb66e5a6139b9b86708957/w/093d288d7231f660efc44c25/e/442d6999fa2e78f6d076b67d (View Post)8 -
Re: Addition and Subtraction in equations in Part Studio
The issue you're experiencing is with units. In most cases, units on dimensions are assumed according to your part studio settings, but when adding and subtracting, both sides of the equation must ha… (View Post)1 -
Re: Possible Editing Logic bug with Array parameters
@konstantin_shiriazdanov, I'm not sure I understand your comment. Mate Connectors are a special type of point body, so they have EntityType.BODY and BodyType.MATE_CONNECTOR. But I think that's a bit … (View Post)1 -
Re: Getting (x,y,z) components of 3D line?
You can actually click the measuring icon in the bottom right corner to pop up additional information about your measurement selection. For example, if you click two points, Onshape will actually rep… (View Post)1
