Welcome to the Onshape forum! Ask questions and join in the discussions about everything Onshape.
First time visiting? Here are some places to start:- Looking for a certain topic? Check out the categories filter or use Search (upper right).
- Need support? Ask a question to our Community Support category.
- Please submit support tickets for bugs but you can request improvements in the Product Feedback category.
- Be respectful, on topic and if you see a problem, Flag it.
If you would like to contact our Community Manager personally, feel free to send a private message or an email.
_Ðave_ ✭✭✭✭
Reactions
-
Re: How to loft between two sketches?
@David_65 You created sketch #2 from the face of the base. The base is smaller than your sketch and therefore I believe that it creates some undesirable results in which I can't explain. But by creat… (View Post)1 -
Re: Importing a mesh file into Onshape
At this time, no. There as been some discussion about this and likely has been requested. You should add your vote or request raise a ticket using feedback. (View Post)3 -
Re: Drawing circle cuts hole in plate
@jay_williams The below video may help explain. (View Post)1 -
Re: Improvements to Onshape - May 6th, 2016
Thanks _Ðave_ (View Post)1 -
Re: Too slow to load in New Zealand
I also feel that Onshape's performance as decreased recently but because on my slow internet speeds (slightly slower than Don's) I felt that the issue was on my end. (View Post)1
