Welcome to the Onshape forum! Ask questions and join in the discussions about everything Onshape.
First time visiting? Here are some places to start:- Looking for a certain topic? Check out the categories filter or use Search (upper right).
- Need support? Ask a question to our Community Support category.
- Please submit support tickets for bugs but you can request improvements in the Product Feedback category.
- Be respectful, on topic and if you see a problem, Flag it.
If you would like to contact our Community Manager personally, feel free to send a private message or an email.
-
Re: Improvements to Onshape - September 18, 2015
Slot tool is awesome. It helps a lot for creating cooling lines in mold cavities for low pressure die cast molds. Otherwise creating the slot sketch includes manual task of constraining and creating … (View Post)3 -
Re: Measure to hole center, not Min Dist
@stg434 Present color coding of measurement lines in the model is referred from the view cube X, Y and Z lines. (View Post)1 -
Polygon creation
Currently to define the number of sides for polygon we move the mouse to a direction until we get the number as shown below. It requires some judgement to adjust the number, however I agree that it i… (View Post)2 -
Re: Beyond system limits
@don_howe I tried putting the value in inches as suggested by you. Below is a result. Regarding limit I definitely agree with you. The limit of Onshape is different from unit to unit. (View Post)1 -
Re: Equal constraint - Use with Care between sketches
Just now I checked this condition in Creo and found that same results appear as @da_vicki explained about parallel and normal planes. But in Creo we can apply parametric relations between sketch dime… (View Post)1
