Welcome to the Onshape forum! Ask questions and join in the discussions about everything Onshape.
First time visiting? Here are some places to start:- Looking for a certain topic? Check out the categories filter or use Search (upper right).
- Need support? Ask a question to our Community Support category.
- Please submit support tickets for bugs but you can request improvements in the Product Feedback category.
- Be respectful, on topic and if you see a problem, Flag it.
If you would like to contact our Community Manager personally, feel free to send a private message or an email.
-
Re: Has anyone used a Microsoft Lumina with Onshape?
Onshape is not supported to windows phone platform yet since Internet explorer is not supported for Onshape. See this discussion https://forum.onshape.com/discussion/717/any-plans-for-onshape-in-wind… (View Post)6 -
Re: INTERFERENCE DETECTION
@Maxi At present the available interference detection is not exact as in Solidworks but as a work around you can see the interference in section tool itself. Areas which are intersected are highlight… (View Post)0 -
Re: Editing on Assembly?
At this point of time there is no provision to insert features in assembly. But for such scenario there is very good alternative method of using derived feature in part studio. Before making assembly… (View Post)7 -
Re: Improvements to Onshape - December 14th, 2016
Special thanks for curve and centered pattern!! (View Post)1 -
Re: Extrude didn't regenerate properly
@tivadar_kecskes I just observed the sketch which is shared by you. It shows that lines are not coinciding to the circle as highlighted below. You will able to see it when you zoom in that area. Go t… (View Post)6