Welcome to the Onshape forum! Ask questions and join in the discussions about everything Onshape.First time visiting? Here are some places to start:
- Looking for a certain topic? Check out the categories filter or use Search (upper right).
- Need support? Ask a question to our Community Support category.
- Please submit support tickets for bugs but you can request improvements in the Product Feedback category.
- Be respectful, on topic and if you see a problem, Flag it.
I am new to Onshape so I am working through converting some Solidworks parts to Onshape as an exercise.
I have a round lid part that has some ribs around the rim. These have a reverse fillet around them.
Can this be done in onshape?
Thanks for any suggestions.