Welcome to the Onshape forum! Ask questions and join in the discussions about everything Onshape.
First time visiting? Here are some places to start:- Looking for a certain topic? Check out the categories filter or use Search (upper right).
- Need support? Ask a question to our Community Support category.
- Please submit support tickets for bugs but you can request improvements in the Product Feedback category.
- Be respectful, on topic and if you see a problem, Flag it.
If you would like to contact our Community Manager personally, feel free to send a private message or an email.
Simple cube?
alexander_potochkin
Member Posts: 45 ✭✭
Hello
This must be a very basic stuff - but I can't figure out how to make a cube in a right way.
So I did the following:
1) Made a square
2) Extruded it
3) And here I stuck, since I wanted it to be extruded to the exact length of the base square's side,
so I could change its length and have my cube size properly recalculated.
Could you point out to the right tutorial/webinar/whatever please?
Thanks a lot!
2) Extruded it
3) And here I stuck, since I wanted it to be extruded to the exact length of the base square's side,
so I could change its length and have my cube size properly recalculated.
Could you point out to the right tutorial/webinar/whatever please?
Thanks a lot!
Tagged:
0
Answers
OK, only TWO to go!
to others : sorry , private jest