Welcome to the Onshape forum! Ask questions and join in the discussions about everything Onshape.

First time visiting? Here are some places to start:
  1. Looking for a certain topic? Check out the categories filter or use Search (upper right).
  2. Need support? Ask a question to our Community Support category.
  3. Please submit support tickets for bugs but you can request improvements in the Product Feedback category.
  4. Be respectful, on topic and if you see a problem, Flag it.

If you would like to contact our Community Manager personally, feel free to send a private message or an email.

Hole did not regenerate properly

T3WIT3WI Member Posts: 5
Hello,

I am trying to add holes using the grey sketch in a part as seen below. I wanted to know why I am getting this error, as this has happened a few times already, and have gotten around it by just extruding circles. I've linked my part below, if needed.


Link to Part

Thank you!

Best Answer

  • james_aguilar160james_aguilar160 Member Posts: 46
    Answer ✓
    It is because of the fastener fit you've selected:
    • Fastener fit - Available only for Straight tap Tap type when 2 or more parts are selected in the Merge scope field. Select from None, Close, Free, Close (ASME), Normal (ASME), Loose (ASME).

Answers

  • robert_scott_jr_robert_scott_jr_ Member Posts: 495 ✭✭✭
    Try Up To Face as the termination. - Scotty
  • T3WIT3WI Member Posts: 5
    There is no Up To Face, only Up To Entity. Using that has the same error
  • james_aguilar160james_aguilar160 Member Posts: 46
    Answer ✓
    It is because of the fastener fit you've selected:
    • Fastener fit - Available only for Straight tap Tap type when 2 or more parts are selected in the Merge scope field. Select from None, Close, Free, Close (ASME), Normal (ASME), Loose (ASME).
Sign In or Register to comment.