Welcome to the Onshape forum! Ask questions and join in the discussions about everything Onshape.

First time visiting? Here are some places to start:
  1. Looking for a certain topic? Check out the categories filter or use Search (upper right).
  2. Need support? Ask a question to our Community Support category.
  3. Please submit support tickets for bugs but you can request improvements in the Product Feedback category.
  4. Be respectful, on topic and if you see a problem, Flag it.

If you would like to contact our Community Manager personally, feel free to send a private message or an email.

problem with assembly introduction lesson

kathleen_geraedts
kathleen_geraedts Member Posts: 2 ✭
in Learning Center

I am trying to complete the Onshape Assembly Basics found on https://learn.onshape.com/learn/article/assembly-introduction-lesson. But within the finale exercise (Extra Practice: assembly practice 4), I get immediately the following: Cylinder <1> has error: Failed to resolve instance.

This part cannot be used therefore. Could this be repaired, so we can make the whole exercise? Thanks in advance.

Categories