Welcome to the Onshape forum! Ask questions and join in the discussions about everything Onshape.

First time visiting? Here are some places to start:

  1. Looking for a certain topic? Check out the categories filter or use Search (upper right).
  2. Need support? Ask a question to our Community Support category.
  3. Please submit support tickets for bugs but you can request improvements in the Product Feedback category.
  4. Be respectful, on topic and if you see a problem, Flag it.

If you would like to contact our Community Manager personally, feel free to send a private message or an email.

Inconsistent spline escape behavior.

SystemSystem 40202Posts: 5
edited April 2018 in Community Support
This discussion was created from comments split from: Learning Center Support.


  • larry_haweslarry_hawes Member Posts: 429 PRO
    Inconsistent spline escape behavior.

    When drawing almost any sketch item a right click will allow 'escape' then exit the mode. When sketching a spline selecting 'escape spline' deletes the spline. The escape key escapes spline mode but right clicking and choosing escape spline deletes the spline - unexpected.

Sign In or Register to comment.