Help With PCB Tutorial - Instructions Not Producing Same Results

I'm trying to do "Exercise: Creating a PCB Board" from section 3 of the tutorial. I am not getting results that match what is shown.

I've gone through each step multiple times and tried to verify every tiny detail, but I can't find what is different.

I continue to end up with a PCB Studio that reports 0 components and 2 keep-out areas, but then only shows the green outline of the PCB and no visual for either of the keep-out areas.

Screenshot 2025-11-24 at 4.55.38 AM.png

Not surprisingly, the export contents also do not correspond, so it's not just a display issue.

I imagine it's something simple, but I'm at a loss for the moment. Any help would be much appreciated!

Document available here: There was an error displaying this embed.

Answers

  • AsherAtSignalDesign
    AsherAtSignalDesign Member Posts: 34 PRO

    I've tried verifying the link from a private session and it tells me no permission. Unclear why, as I have both enabled link sharing and also made the document public. I'm on a teams trial. Please let me know if it's also not working for you and you know how to fix it.

  • glen_dewsbury
    glen_dewsbury Member Posts: 1,381 PRO

    When you paste the link and hit enter there may be a little spinning wheel next to the link. Wait for the wheel to stop spinning before posting comments.

  • AsherAtSignalDesign
    AsherAtSignalDesign Member Posts: 34 PRO
    edited November 2025

    There was an error displaying this embed.

    Trying but seems to be same result (no spinning wheel or any indicator). Also, separate from the forum, when I go to the link it seems to have an issue. I'm confused. Isn't this done all the time?