Welcome to the Onshape forum! Ask questions and join in the discussions about everything Onshape.

First time visiting? Here are some places to start:
  1. Looking for a certain topic? Check out the categories filter or use Search (upper right).
  2. Need support? Ask a question to our Community Support category.
  3. Please submit support tickets for bugs but you can request improvements in the Product Feedback category.
  4. Be respectful, on topic and if you see a problem, Flag it.

If you would like to contact our Community Manager personally, feel free to send a private message or an email.

I can't get fillet to work.

jamie_fleck
jamie_fleck Posts: 8 ✭
in Community Support
I have gotten fillet to work on the base already and I can't get it to work on the plunger.  I have it as two parts I have tried it being only one part.  I have tried moving it's location up and down the geometry list.  Any help would be greatly appreciated. 

The file is Pen Cap, by Jamie Fleck, fillet tab

I'm also trying to fillet the clip,  not sure if fillet is even the best way.  I'll start another thread for that.

Thank you in advance


Tagged:

Answers

  • _Ðave_
    _Ðave_ Posts: 712 ✭✭✭✭
    @jamie_fleck The size of your desired fillet is too large to fit, please try a smaller fillet.
  • jamie_fleck
    jamie_fleck Posts: 8 ✭
    Ugh, thanks for the help.  I wish it wasn't something so obvious.
  • olek_bolek
    olek_bolek Posts: 2 ✭
    I was just wondering what the pen cap is for?  Can you share?
  • jamie_fleck
    jamie_fleck Posts: 8 ✭
    I know a pen cap usually goes over a pen.  I didn't know the correct name for the object, I was just using it for practice.
  • olek_bolek
    olek_bolek Posts: 2 ✭
    I see.  You seem like a nice guy.  Want to meet up at Buffalo Wild Wings on Friday at 8?

Categories