Bridging curve

What is the reason that we select Dark Blue's edge and point before selecting Grey's edge in step 1? What is the reason that we select Dark Blue's edge before selecting Grey's edge and point in step 2? et cetera… For what reason are the edges chosen in this manner? I want to understand why a single piece doesn't have all…

I don't have an icon or an explainer page yet, but I wanted people to bang on this and tell me if there are any obvious issues. So things might change, but I hope this is a reasonable approach. For a long time I've wanted to have a way to optionally make both sides of a Bridging curve work the same. I actually did 98% of…

Hello, I am at my wits end, and am hoping someone can guide/help me along to finish my part design. I've included photos below of the part i am trying to model, and my current workspace state. Workspace:…

I've been playing around with this for a while and made some progress but nothing that will work properly so far. I have a revolvled sketch which creates the bottle shape and onto that I am trying to add a pouring spout. I have sketched out the top shape and the side profile. I was trying to wrap the shape onto the surface…

I have just done a test to try and align a Bridging curve over a semi circle, and at no time is the bridging curve semicircular. It is always different. It seems these differences will detract from the ability to make consistent curves, edges and surfaces etc with predictable outcome. The bridging curve with a Magnitude of…