community support

i am using Onshape for VEX Robotics. I am new to this program. I don't know how to get rid of these lines can someone please help me out. look at the image

Hello. In step 6 of Reducer Coupling, after performing all required procedures, I believe, this does not allow me to select a new sketch on the flat face of the revolution labeled as A, therefore, I can not proceed with the exercise ;(…

Hello, I'm having trouble adding a fillet between the Wings and Fuselage in this Project. I can't choose a radius even remotely close to what im after. I would like to add maybe 10 to 15 mm but whenever I try to fillet with more than 1 mm it fails. Creating a 0.5 mm fillet works. A 1mm Fillet prompts the error: "Fillet…

the hexagon diameter is 1.5 and spaced for a patter. the thickness of the part I'm trying to lighten is 0.25. I've tried changing the size of the hexagons as well as changing the thickness of the walls, ribs, and tool Diameter.

if i make a simple sketch and i put a line perpendicular inside of it, it gets over constrained. I have no idea what i done to make a sketch break itself by default, i hope this is user error and not a onshape bug. It automatically adds a dimension, and if i remove it its not over constrained however if i add it back it…

I'm trying to make a latch on a box and I would like the latch to be spaced a certain distance away from a curve, but I'm not sure how to do so. What I want to do is have the furthest left point on this curve spaced a defined distance away from a line laterally. I marked this image up to try to help explain. Link if needed

Hi! I'm basically a complete Onshape beginner, so please bare and be patient with me. I am trying to create a tape dispenser (pic) in onshape, right now working on the body. I've managed to make the bottom part of the body, on which it can already be seen that the front and back have different widths, and the bottom and…