Face blend
Discussion List
-
Trouble with face blend
I'm struggling to get the face blend tool to do what I think it should do. I have a bracket with a "+" profile that's butting up against a base plate. I want to use face blend to flare the webs of the arm out, but it's only drawing a face, not actually making it part of the solid. See the below screenshot: The suggestion…
-
How do I blend the two inside faces too each other? I can't seem to get face blend to work. Plz Help
https://cad.onshape.com/documents/c5684b823c04af1ec354a756/w/4360f2a9b3dae329827ae9f2/e/e1df25300d4c I want to blend a face between the outer perimeter of the center piece to the inner perimeter of the outer piece and can't seem to setup a face blend. Am I doing it wrong? is there a better function to use? any help would…
-
Tapered Recess Creation?
I've been struggling with one aspect of a molded boss feature I'm developing. I've tried a lot of different ways to solve this but getting a general case method that is robust is surprisingly challenging. I'm working on a molded boss feature to rival hole.fs in complexity which takes basic choices for screw type/size and…
-
How can I face blend 3 surfaces?
I have been trying to make this corner more smoothed out, maybe following a similar curvature to the right wall which has a fillet and isn't linear. That didnt work with curves (or i did it wrong). Instead, I would like to "face blend" three surfaces, like pinching out the corner and making it smooth. Only one wall here is…
-
Face blend not completely seamless
Hello everyone, I'm trying to do a face blend with a block to a cylinder but I keep getting this annoying bumps: How do i change the face blend so that the block seamlessly connects to the cylinder?