internal threads
Discussion List
-
How to use ThreadCreator?
I had a hard time creating my first internal threads with ThreadCreator and searched high and low for instructions. Lots of vidoes about how to install TH, but very little about how to use it for internal threads. And what I did find didn't cover some key points. Please chime in with advice. To create internal threads,…
-
Internal thread is "self-blocking" - won't attach to threaded post.
I'm trying to create a replacement tip to thread onto this very course threaded bit (see attached). I have something that seems appropriate to start fit-testing, but the threads seem to "self block" at the exit of the hole. I've tried using Threadlab, and threadcreator. I thought maybe the issue is the # of starts, or a…
-
Metric threads not engaging in cylindrical parts
Hi! I'm designing what will become an electronic light consisting of a two-part construction. The battery and other components will be mounted in an inner cylindrical part that then screws into the outer cylindrical part. The construction will be 3D printed in PLA. I've set the outer diameter of the inner part to 34.7 mm…
-
helical sweep problems
I'm trying to helical sweep a "house" shaped cross-section ( a rectangle on three sides, but an equilateral triangle for the "fourth" side) on the ID of a cylindrical surface. but the dialog box will not allow me to select the helix I've already created on the cylindrical surface. I'm trying to create an internal thread on…