Welcome to the Onshape forum! Ask questions and join in the discussions about everything Onshape.
First time visiting? Here are some places to start:- Looking for a certain topic? Check out the categories filter or use Search (upper right).
- Need support? Ask a question to our Community Support category.
- Please submit support tickets for bugs but you can request improvements in the Product Feedback category.
- Be respectful, on topic and if you see a problem, Flag it.
If you would like to contact our Community Manager personally, feel free to send a private message or an email.
franz_balleis127 ✭
About
- Username
- franz_balleis127
- Joined
- Visits
- 31
- Last Active
- Roles
- Member
- Points
- 23
- Badges
- 5
- Posts
- 16
Reactions
Activity
-
Hello matthew,thank you for your quick reply. The floor confused you a bit and unfortunately I didn't remove it either. The bottom is of course welded in afterwards sorry. The component is then rolled and welded.
the question I had was how I can make a 2D drawing for the laser from this 3D model ?regards Franz0December 2020