Welcome to the Onshape forum! Ask questions and join in the discussions about everything Onshape.
First time visiting? Here are some places to start:- Looking for a certain topic? Check out the categories filter or use Search (upper right).
- Need support? Ask a question to our Community Support category.
- Please submit support tickets for bugs but you can request improvements in the Product Feedback category.
- Be respectful, on topic and if you see a problem, Flag it.
If you would like to contact our Community Manager personally, feel free to send a private message or an email.
GregBrown 
Reactions
-
Re: I need this like yesterday. Surface creation by 3d snap
Yes, Fill has had the ability to add guides (points or curves) all along. However it is completely different code/algorithm than the other one mentioned earlier in this thread. (View Post)1 -
Re: This type of error makes my experience of onshape incredibly frustrating
Use the "Offset" measurement type (View Post)1 -
Re: Beam Deflection Showing Incorrect Result
You have fully fixed boundary conditions for your beam, so your equation should read delta_max = F*L^3/192*E*I Also it is a really nice thing to do these hand calcs using variables: (View Post)1 -
Re: A question about B-Spline to Interpolated-Spline
What is the use case you are intending here? You could approximate a given bspline at degree 3 (which is what interpolated curves are) then extract the position of the knots. This should get you pret… (View Post)2 -
Re: how do I make a flat on a cylindrical tank?
You could split the part using the "flat cutout plane" you just created. Keep (or not) both sides as you require Or many other ways…. (View Post)1
