Welcome to the Onshape forum! Ask questions and join in the discussions about everything Onshape.
First time visiting? Here are some places to start:- Looking for a certain topic? Check out the categories filter or use Search (upper right).
- Need support? Ask a question to our Community Support category.
- Please submit support tickets for bugs but you can request improvements in the Product Feedback category.
- Be respectful, on topic and if you see a problem, Flag it.
If you would like to contact our Community Manager personally, feel free to send a private message or an email.
GregBrown 
Reactions
-
Re: How to make the transition from a chamfered edge to an unchamfered edge?
In this document (https://cad.onshape.com/documents/a059937493dfe00304609db6/w/571737312ebae8a479dcd4b7/e/4c217bed875f3399cb6f08cd) I have a slightly different way that is less picky - had only 8 lof… (View Post)2 -
Re: Can't subtract derived part but don't know why
When you are trying to "Offset all", you are automatically including a LOT of faces that really have no impact on the cutout, except of course to mess it up. If you just do the Boolean subt… (View Post)1 -
Re: Connect face to angled curved surface
Face blend with hold line (View Post)1 -
Re: Routing curve & Control point curve - Introduction of two new features for 3D curve creation
https://forum.onshape.com/discussion/comment/114174#Comment_114174 Jonathan, thanks for the feedback and continued interest in this feature… Firstly, how many points are in your Routing curve array? … (View Post)1 -
Re: How to prevent unintended/undesired constraints
If you keep the shift key pressed while placing a sketch element then the automatic constraint inferences will be ignored. (View Post)3
