Welcome to the Onshape forum! Ask questions and join in the discussions about everything Onshape.
First time visiting? Here are some places to start:- Looking for a certain topic? Check out the categories filter or use Search (upper right).
- Need support? Ask a question to our Community Support category.
- Please submit support tickets for bugs but you can request improvements in the Product Feedback category.
- Be respectful, on topic and if you see a problem, Flag it.
If you would like to contact our Community Manager personally, feel free to send a private message or an email.
MDesign PRO
Reactions
-
Re: bend face, or i dont know help
Without access to your document it will be hard to determine the cause of fragments. You will have to provide a link so that everyone can see what you did to get to the point you are. (View Post)1 -
Re: Is there a way to view your extruded model in sketch mode?
Use this button. (View Post)2 -
Re: Creating seamless transitions between two lofts
Zebras are cool too. Top one more fluid than bottom (View Post)1 -
Re: where is the enclosed volume of this pillbox?
https://forum.onshape.com/discussion/comment/111818#Comment_111818 switch to transparent view. make new extrusion from bottom interior face to top face as a new part and measure that new part. (View Post)1 -
Re: Creating seamless transitions between two lofts
Found it. Yes you need to set end profile condition to normal in Loft2 and in Loft1 set the 1st two guide profiles continuity to Normal (View Post)2
