Welcome to the Onshape forum! Ask questions and join in the discussions about everything Onshape.
First time visiting? Here are some places to start:- Looking for a certain topic? Check out the categories filter or use Search (upper right).
- Need support? Ask a question to our Community Support category.
- Please submit support tickets for bugs but you can request improvements in the Product Feedback category.
- Be respectful, on topic and if you see a problem, Flag it.
If you would like to contact our Community Manager personally, feel free to send a private message or an email.
MDesign PRO
Reactions
-
Re: How do I do this (newbie)
When doing symmetrical stuff try to break it down to a single repeatable piece of geometry to simplify things and use the bare min of constraints. In the case of your extrusion, you can easily see yo… (View Post)1 -
Re: New Custom Feature: Standard Bearing
2 -
Re: I design a cylinder say 10mm diameter and it prints at 4.7mm diameter?
sounds awfully close to a mix up between radius and diameter. (View Post)1 -
Re: Mesh imports but doesn't show up in parts studio
It's right there in front of you…Actually its super tiny…LOL Just update the units of the import and it'll rescale appropriately. (View Post)1 -
Re: How to fill this surface
seems like overkill with that many guides unless you really need specific surface control like that.. there is a trim guides checkbox that should work if your guides run long. (View Post)1
