Welcome to the Onshape forum! Ask questions and join in the discussions about everything Onshape.
First time visiting? Here are some places to start:- Looking for a certain topic? Check out the categories filter or use Search (upper right).
- Need support? Ask a question to our Community Support category.
- Please submit support tickets for bugs but you can request improvements in the Product Feedback category.
- Be respectful, on topic and if you see a problem, Flag it.
If you would like to contact our Community Manager personally, feel free to send a private message or an email.
Matt_Shields 
Reactions
-
Re: Angled hole
Use a mate connector for your sketch plane. Then angle the mate connector. (View Post)2 -
Re: Introduction to Onshape Simulation - lesson
Simulation is available for Educator accounts, not Student accounts. In order for students to be able to perform simulations, they need to be added to an Educator's Classroom. (View Post)1 -
Re: Tracing over images.. is Onshape really bad at this or am I?
I think you would learn a ton about best practices by taking a couple of Learning Center courses. In this course, they do a couple examples similar to what you are trying to do. (View Post)1 -
Re: Shell Thickness
Outer diameter is 130 mm. Inner diameter is 126 mm. Outer radius is 65 mm. Inner radius is 63 mm. 65 - 63 = 2. (View Post)1 -
Re: Problem with Parametric Curve FS
If #R, #E, etc. are just numbers, then don't divide them by mm. Everything inside a trig function needs to be an angle and every parameter needs to be a distance. So, something like #R * cos(#t*radia… (View Post)1
