Welcome to the Onshape forum! Ask questions and join in the discussions about everything Onshape.
First time visiting? Here are some places to start:- Looking for a certain topic? Check out the categories filter or use Search (upper right).
- Need support? Ask a question to our Community Support category.
- Please submit support tickets for bugs but you can request improvements in the Product Feedback category.
- Be respectful, on topic and if you see a problem, Flag it.
If you would like to contact our Community Manager personally, feel free to send a private message or an email.
POC PRO
Reactions
-
SHEET METAL COUNTERSUNK HOLE ISSUE
Hi The countersink routine does not produce a countersunk feature on my sheetmetal part? it inserts a circular hole If I duplicate the process on a standard extruded shape everything works as expecte… (View Post)1 -
Re: SHEET METAL COUNTERSUNK HOLE ISSUE
I started this thread - to overcome the issue I had to add a "simple" hole slightly smaller than required in the required locations while in Sheet Metal mode then after "Finishing Shee… (View Post)1 -
Linear Pattern - Issue with Qtys
The linear patter routine is duplicating parts incorrectly, doubling the required qty..but visually looks fine,, however results in incorrect BOM qty's. This was not the case previously... (View Post)1 -
Re: Newbie question: How can I center 2 parts in an Assembly ... at a fixed offset distance?
Add a mate connector to the edge of the chamfers, then use fastened mate with offsets. (View Post)2 -
Re: Part Studio Configuration + Config Properties
Thanks for suggestion, I don't think it will be suitable in this particular case - I've modified the properties now in any case - just posting in case anyone else had a faster method (View Post)1