Welcome to the Onshape forum! Ask questions and join in the discussions about everything Onshape.
First time visiting? Here are some places to start:- Looking for a certain topic? Check out the categories filter or use Search (upper right).
- Need support? Ask a question to our Community Support category.
- Please submit support tickets for bugs but you can request improvements in the Product Feedback category.
- Be respectful, on topic and if you see a problem, Flag it.
If you would like to contact our Community Manager personally, feel free to send a private message or an email.
S1mon PRO
Reactions
-
Re: splitting slected sketch
You can't split a revolved face on one side. What you probably need/want to do is cut a very tiny amount off the top, and extrude a very thin cut down the side where you wanted to split. Then you can… (View Post)1 -
Re: Translating a part leaves sketches, extrusions, etc behind
It would help you a lot to learn how to fully constrain your sketches. If you clean them up and constrain them and dimension them from the origin you can put the part where it should be. https://lear… (View Post)1 -
Re: DXF / DWG EXPORT UNITS
One would hope that with the next release that Onshape can come up with an intelligent fix for this. I'm happy to be able to set units for export, but the way that it defaults back to meters is a big… (View Post)4 -
Re: Drawing a corner rectangle centered about the origin
I assume you mean a rectangle without a center? You can use the midpoint constraint with two diagonal points of a rectangle and the origin. Just make sure that the origin is inside the rectangle firs… (View Post)1 -
Re: How do I convert these simple 3 sketches into a sheet metal part?
Turn them into surfaces using Offset surface with a zero offset. Boolean them together and then use sheet metal with Thicken. (View Post)1
