Welcome to the Onshape forum! Ask questions and join in the discussions about everything Onshape.
First time visiting? Here are some places to start:- Looking for a certain topic? Check out the categories filter or use Search (upper right).
- Need support? Ask a question to our Community Support category.
- Please submit support tickets for bugs but you can request improvements in the Product Feedback category.
- Be respectful, on topic and if you see a problem, Flag it.
If you would like to contact our Community Manager personally, feel free to send a private message or an email.
glen_dewsbury PRO
Reactions
-
Re: Sweeping only works with corners but not with curves
Your radius on the sweep path is too tight and folds back on it's self. Notice in sample picture what happens if the 25 radius in the path gets much smaller. The inner radius try's to be negative. (View Post)1 -
Re: How do I make the flat piece meet cylinder smoothly?
Your question does make sense because of the non manifold condition. I tried to use the rib tool and had the same issue. I made a rib profile (wing) with a small over lap then extruded. https://cad.o… (View Post)2 -
Re: How can I wrap a solid to a curved Surface?
Here is one way to accomplish the wrap using a surface and thicken. Additional chamfers for the profile are added after. Solids don't wrap as far as I know. https://cad.onshape.com/documents/940f3cfc… (View Post)1 -
Re: lofting from a sketch gets screwed up by other sketches on the same plane
Cast a vote here. https://forum.onshape.com/discussion/comment/101644#Comment_101644 (View Post)2 -
Re: Ribs connecting two lofts?
Nice job John. I was too slow this afternoon with my response. My results were very similar. To reiterate some of John's notes. Sketches want to be fully constrained starting from the origin to keep … (View Post)1
