Welcome to the Onshape forum! Ask questions and join in the discussions about everything Onshape.First time visiting? Here are some places to start:
- Looking for a certain topic? Check out the categories filter or use Search (upper right).
- Need support? Ask a question to our Community Support category.
- Please submit support tickets for bugs but you can request improvements in the Product Feedback category.
- Be respectful, on topic and if you see a problem, Flag it.
If you would like to contact our Community Manager personally, feel free to send a private message or an email.
Re: Macbook Pro hardware recommendations wanted: GPU vs CPU vs Memory & M370XHow clean is the charging port? Is is relatively easy to replace. I am also using my Macbook in my workshop where I also do some metalwork. Due to the fact that the chassis is magnetic, sometimes sma… (View Post)1
Re: Change angle of end design2
Re: Change angle of end designThanks Eduardo and Jake! I had not even seen the response from Eduardo while posting my link. Did not expect "move face" could do the trick. Was only familiar with the offset direction. Tha… (View Post)2
Re: Sheet metal flange / design approach questionThanks! I indeed think it had to do with the corner relief. After examining those to bottom parts closer they were not the same width due to the fact that I had already added flanges. So I combined t… (View Post)2
Sheet metal flange / design approach questionI'm in the process of converting my 1967 Volvo Amazon wagon to full electric and currently designing my battery boxes. Those are made of beams to hold the battery modules and a box skin made out of 1… (View Post)1