Welcome to the Onshape forum! Ask questions and join in the discussions about everything Onshape.
First time visiting? Here are some places to start:- Looking for a certain topic? Check out the categories filter or use Search (upper right).
- Need support? Ask a question to our Community Support category.
- Please submit support tickets for bugs but you can request improvements in the Product Feedback category.
- Be respectful, on topic and if you see a problem, Flag it.
If you would like to contact our Community Manager personally, feel free to send a private message or an email.
-
Re: Differences between Onshape and Solidworks
cheers thanks for the response! ill just have to have a go at it...........I wish these companies used ONSHAPE instead!!! (View Post)1 -
Re: Do You Have A Nice Model To Show? (DYHANMTS_2017)
Here is the four seat version of Hawk model i posted above this is the Falcon. Uses the same outer wings Horizontal and vertical tail surfaces. Getting it to look right based off photos and measureme… (View Post)8 -
Re: Do You Have A Nice Model To Show? (DYHANMTS_2017)
A bit more progress on the Hawk. The New(ish) Curve tools such as 3D fit spline Were a big help in doing the engine cowls and wing fillets. All of it was lofted from 2D profiles. I also attached a pd… (View Post)10 -
Re: #TraditionalCADsucks
In a previous job i used CATIA professionally....I then started using onshape about two years ago as it was available and it did the job. Although it still lacks some functionality that CATIA has..(I… (View Post)10 -
Re: Do You Have A Nice Model To Show? (DYHANMTS_2017)
This is model of a Miles Hawk/ Falcon Wing. A all wood 1930's British Light aircraft. The plan is to draw up the model based on drawings and measurements taken from one of the few that are in existen… (View Post)12
