Welcome to the Onshape forum! Ask questions and join in the discussions about everything Onshape.
First time visiting? Here are some places to start:- Looking for a certain topic? Check out the categories filter or use Search (upper right).
- Need support? Ask a question to our Community Support category.
- Please submit support tickets for bugs but you can request improvements in the Product Feedback category.
- Be respectful, on topic and if you see a problem, Flag it.
If you would like to contact our Community Manager personally, feel free to send a private message or an email.
robert_scott_jr_ ✭✭✭
Reactions
-
Re: how do i centre holes?
Most of the time, here's how I do it. Construction line corner to corner. Place point at center of construction line. - Scotty Document (View Post)1 -
Re: Boolean Union operation to preserve holes from both tools
Hello Herb. After the transforms, create a sketch on either exposed face of the two parts, a parallel plane or a mate connector. Using the Use tool, capture all the holes you need. After the Boolean,… (View Post)1 -
Re: Answered: How to dimension to midpoint?
Or just a point. - Scotty (View Post)3 -
Re: Need to provide support for cylinders
Hey Spencer. The terminology you used is understood. This document demonstrates how to create the rib(s). - Scotty (View Post)1 -
Re: Bend/Slope Help
Hello Thayne. Perhaps a simpler approach would be to create a sketch of straight lines that represent the flat areas of the tray, use the Extrude Thin tool to create 3 flat areas and see if what you … (View Post)1
