Welcome to the Onshape forum! Ask questions and join in the discussions about everything Onshape.
First time visiting? Here are some places to start:- Looking for a certain topic? Check out the categories filter or use Search (upper right).
- Need support? Ask a question to our Community Support category.
- Please submit support tickets for bugs but you can request improvements in the Product Feedback category.
- Be respectful, on topic and if you see a problem, Flag it.
If you would like to contact our Community Manager personally, feel free to send a private message or an email.
tj_thorniley ✭
Reactions
-
Re: Lining up sketches on different planes
All good. The 'use‘ tool is all I needed. If anyone else needs help; it basically allows you to superimpose lines, points, etc from earlier sketches, to new planes. Its like you can reach over and gr… (View Post)2 -
How to remove several constraints at a time?
I often want to revisit a previous design and make small changes, tune the dimensions, etc. But every time I do that, it ends up over constraining the sketch, or some similar issue. How can I remove … (View Post)1 -
Re: Plane axis tilt
@Tony_C_ You're the man. Thats what I was looking for. Actually, in this instance I had to set the angle to 105º to remain flush with the tangent surfaces. (View Post)1 -
Re: How to concave a flat surface?
Thanks for the quick replies fellas. I did try something like that, but to no avail. I'll try it again in a bit, with your examples to guide me. Hopefully this helps someone else too. By the way, how… (View Post)1