Welcome to the Onshape forum! Ask questions and join in the discussions about everything Onshape.
First time visiting? Here are some places to start:- Looking for a certain topic? Check out the categories filter or use Search (upper right).
- Need support? Ask a question to our Community Support category.
- Please submit support tickets for bugs but you can request improvements in the Product Feedback category.
- Be respectful, on topic and if you see a problem, Flag it.
If you would like to contact our Community Manager personally, feel free to send a private message or an email.
Loft Error - Can anyone tell me what is going on here?
scott_lipsham
Member Posts: 2 ✭
Hi all - Newbie here
Trying to do simple loft between top of milk jug and round base - should seem simple.
Keep getting this weird error when lofted
many thanks
Scott
Trying to do simple loft between top of milk jug and round base - should seem simple.
Keep getting this weird error when lofted
many thanks
Scott
0
Best Answers
-
john_mcclary Member, Developers Posts: 3,938 PROYou may need to add some guide curves, or split the lower circle and match verticies5
-
John_P_Desilets Onshape Employees, csevp Posts: 253Hello @scott_lipsham
As @john_mcclary said, splitting the lower profile will do the trick.
This feature has six points.
Using the split command in the sketch toolbar, I split the second profile to match the same number of points as the first profile. Below is a top view of both sketches visible in the graphics area.
Second profile after being split
Here is the end result. Hope this helps!
https://cad.onshape.com/documents/9c284dd0668f6702b9dfe33b/w/814f2ff1d93d189b7281ba7b/e/7c680d1dbf38f1c20100af3b
7
Answers
As @john_mcclary said, splitting the lower profile will do the trick.
This feature has six points.
Using the split command in the sketch toolbar, I split the second profile to match the same number of points as the first profile. Below is a top view of both sketches visible in the graphics area.
Second profile after being split
Here is the end result. Hope this helps!
https://cad.onshape.com/documents/9c284dd0668f6702b9dfe33b/w/814f2ff1d93d189b7281ba7b/e/7c680d1dbf38f1c20100af3b