Welcome to the Onshape forum! Ask questions and join in the discussions about everything Onshape.
First time visiting? Here are some places to start:- Looking for a certain topic? Check out the categories filter or use Search (upper right).
- Need support? Ask a question to our Community Support category.
- Please submit support tickets for bugs but you can request improvements in the Product Feedback category.
- Be respectful, on topic and if you see a problem, Flag it.
If you would like to contact our Community Manager personally, feel free to send a private message or an email.
How to form a Helix along a 3D curve
christopher_auger_dominguez
Member Posts: 2 PRO
I have a bent tube of the same diameter that has turns. I'd like to create a helix that follows the center line of the tube. I can't figure out either to create a curve/spline from the center point of the tube and/or create a Helix that follows the center line or follows the tube.
Tagged:
0
Best Answer
-
S1mon
Member Posts: 3,039 PRO
You may want to create the centerline of your tube first, and then sweep it.
After that, take a look at this FeatureScript from @konstantin_shiriazdanov
https://cad.onshape.com/documents/59007ff281e43510ea3797a2/w/a6cb15bca8f1b2bf6e312ccd/e/7517d8bd0162caff9f9cb2a7
1
Answers
After that, take a look at this FeatureScript from @konstantin_shiriazdanov
https://cad.onshape.com/documents/59007ff281e43510ea3797a2/w/a6cb15bca8f1b2bf6e312ccd/e/7517d8bd0162caff9f9cb2a7